Difference between revisions of "Determining the Half Life of 234mPa"
From mn/safe/nukwik
Line 1: | Line 1: | ||
+ | Return to [[Lab Exercise with 234Th/234Pa Radionuclide Generator|Main]] | ||
+ | |||
+ | |||
+ | |||
Before you plot the data subtract the background counts from each measurement and calculate the uncertainty for each point. | Before you plot the data subtract the background counts from each measurement and calculate the uncertainty for each point. | ||
Line 7: | Line 11: | ||
#Estimate the uncertainty in your fit by drawing two worst-case lines through your data, one with the steepest possible slope and one with the least possible slope. Analyse these lines in the same way as the main line - the respective half lives indicate your lower and upper uncertainty limits. | #Estimate the uncertainty in your fit by drawing two worst-case lines through your data, one with the steepest possible slope and one with the least possible slope. Analyse these lines in the same way as the main line - the respective half lives indicate your lower and upper uncertainty limits. | ||
− | |||
− | [[Category:Laboratory_exercise]][[Category:Half_life]][[Category:Detection]] | + | |
+ | [[Category:Laboratory_exercise]] [[Category:Half_life]] [[Category:Detection]] |
Revision as of 14:44, 28 June 2012
Return to Main
Before you plot the data subtract the background counts from each measurement and calculate the uncertainty for each point.
- Plot your measured data on a A3-sized semi-logarithmic paper. Your data should lie on a straight line (why?). Fit the best possible line through your data. Remember to plot the uncertainty also.
- Select a point on your fitted line from the left side (e.g. 1000 counts), note the corresponding time, t1.
- Now, divide the number of counts for t1 by 2 three times (for 1000 counts you get 125) and find the time, t2, your fitted line passed through this number of counts.
- The difference between t1 and t2 corresponds to three half lives (why?).
- Estimate the uncertainty in your fit by drawing two worst-case lines through your data, one with the steepest possible slope and one with the least possible slope. Analyse these lines in the same way as the main line - the respective half lives indicate your lower and upper uncertainty limits.