Difference between revisions of "KJM5911 Lab Exercise 3 - Gamma Spectroscopy"
From mn/safe/nukwik
Jonpo@uio.no (talk | contribs) (→Learning Goals) |
Jonpo@uio.no (talk | contribs) (→Experimental Procedure) |
||
Line 20: | Line 20: | ||
=== Experimental Procedure === | === Experimental Procedure === | ||
+ | |||
+ | *Part 1: Measurements | ||
+ | **Get familar with the detector system and Maestro | ||
+ | **Make energy calibration for Maestr | ||
+ | **Measure various calibration point-sources (sealed) | ||
+ | **Measure various large-volum calibration sources | ||
+ | **Measure some unknown sources | ||
+ | *Part 2: Energy calibration | ||
+ | **Analyse the calibration spectra, for each "good" gamma-peak write down fitted centroid (channel number), net count, FWHM, fitted energy (from Maestro), and library energy (from Berkeley/Lund database). | ||
+ | **Make (in Origin) a plot of library energy as function of gamma-peak centroid (channel number). Then make a linear fit to the data. | ||
+ | *Part 2: Efficiency calibration | ||
=== Safety Aspects === | === Safety Aspects === |
Revision as of 20:16, 14 October 2012
Warning - under construction - you are welcome to read it, but it will change...
Learning Goals
After completing this exercise you should:
- Understand the processes by which gamma radiation is absorbed in the detector.
- Understand how the detector (and it's electronics) transform the absorbed energy from the gamma rays into electrical pulses which is continuously sorted according to pulse height and presented as a histogram (number of events vs. energy) - a "spectrum".
- Know the basic parameters of a spectroscopy system (spectrum, real time, life time, dead time, channels, etc.).
- Know the relationship between channel number and energy, how to derive this relationship ("energy calibration") and be able to evaluate it's uncertainty.
- Recognise the different parts of a gamma-ray spectrum.
- Know how "peaks" in the spectrum are analysed and understand the results (you should understand terms like: ROI, gross count, net count, peak fitting, FWHM, etc.). You should understand how the software calculate and subtract the background under the peaks.
- Know the relationship between number of counts and gamma-rays emitted by the source (and the disintegration rate). I.e. how to perform an efficiency calibration.
Theory
- Introduction to Gamma Radiation
- Gamma Spectroscopy and Detectors
- The Theory behind Calibration of a Gamma Detector
Experimental Procedure
- Part 1: Measurements
- Get familar with the detector system and Maestro
- Make energy calibration for Maestr
- Measure various calibration point-sources (sealed)
- Measure various large-volum calibration sources
- Measure some unknown sources
- Part 2: Energy calibration
- Analyse the calibration spectra, for each "good" gamma-peak write down fitted centroid (channel number), net count, FWHM, fitted energy (from Maestro), and library energy (from Berkeley/Lund database).
- Make (in Origin) a plot of library energy as function of gamma-peak centroid (channel number). Then make a linear fit to the data.
- Part 2: Efficiency calibration
Safety Aspects
Theory
- Student Guide - Efficieny Calibration Curve
- Student Guide - Determination of Unknown Sample
- Student Guide - Summary of Gamma Spectroscopy Analysis