Difference between revisions of "20210319 3Dcell labnotes"
From mn.fysikk.laglivlab
Dagkd@uio.no (talk | contribs) m |
Dagkd@uio.no (talk | contribs) m |
||
| Line 7: | Line 7: | ||
* continued until almost all bubbles gone | * continued until almost all bubbles gone | ||
* poured carefully over mask and put into oven | * poured carefully over mask and put into oven | ||
| + | |||
| + | === Preparing for the next steps === | ||
| + | |||
| + | * 4 medium and 2 big circuits made were not destroyed by breaking the wafer | ||
| + | * Find cover slips and clean. They all fit on 18x24mm cs found in drawer by plasma machine | ||
| + | * Cut loose and peel off master | ||
| + | * punch holes for 1/16" tubes | ||
| + | * clean with tape | ||
| + | * plasma treat PDMS and CS | ||
| + | * bond | ||
| + | * connect tubes | ||
| + | * fill circuits with distilled water | ||
Revision as of 15:03, 19 March 2021
Casting PDMS 10:1
- poured about 40 ml into disposable beaker on the balance: 32.2g
- poured curing agent by hand until weight was 35.4 g
- mixed. lots of bubbles in mixture
- put beaker in vacuum chamber
- cycled vacuum / air several times to make and break bubbles
- continued until almost all bubbles gone
- poured carefully over mask and put into oven
Preparing for the next steps
- 4 medium and 2 big circuits made were not destroyed by breaking the wafer
- Find cover slips and clean. They all fit on 18x24mm cs found in drawer by plasma machine
- Cut loose and peel off master
- punch holes for 1/16" tubes
- clean with tape
- plasma treat PDMS and CS
- bond
- connect tubes
- fill circuits with distilled water
