Difference between revisions of "Photolitho20231220"
m (Tag: Visual edit) |
m (Tag: Visual edit) |
||
Line 37: | Line 37: | ||
Delay after UV exposure: 10 min. | Delay after UV exposure: 10 min. | ||
− | ''' | + | '''Post-bake: (5 sec@48°C), 15 min@65°C, 40 min @95°C.''' |
Develop in PGMEA: 3 min | Develop in PGMEA: 3 min |
Latest revision as of 15:56, 21 December 2023
GM 1070 for thickness 25 um
Film masks: MP04-Lines with width 10/20/40 um, MP05-L-shape and Umbrella
Results: MP04-fine, 40 um line looks ok, 20 um line is narrower than mask, 10 um line is not successful.
MP05-bad, accidentally developed twice.
Notes from using hotplate:
1-Set Program 1 to 22°C is useless, during Pre-bake, after switching on, the temperature goes to 65°C very rapidly. It seems to skip Program 1 and go straight to Program S1
2-Alternative and useful: during Post-bake, I set Program S1 to be 5 sec@48°C, with ramp speed =2, (Program S2 to be 65°C, Program S2 to be 95°C), temperature rises slowly.
3-I also set Program S4 to be 18°C, with ramp speed = 6, but it cools down too slowly anyway. The best is to turn off the machine and take out wafers.
Steps:
Day 0,
Take out the GM 1070 aliquot from the fridge (NA)
Day 1,
Clean 2 wafers with isopropanol + plasma (2 mins)
Spin coat speed: 3100 rpm, 40 sec
Relax time: 1 hour.
Pre-bake: 15 min@65°C, 35 min @95°C.
Exposure dose: 155~310 mJ/cm2 (divide the number from the datasheet, 620, by factor 2 to 4)
Exposure time: 20% power, 25s
Delay after UV exposure: 10 min.
Post-bake: (5 sec@48°C), 15 min@65°C, 40 min @95°C.
Develop in PGMEA: 3 min
Hard Bake using VWR hot plate 2 hours@135°C
Interferometer