Difference between revisions of "Hot plate programming"
From mn.fysikk.laglivlab
Dagkd@uio.no (talk | contribs) (Created page with "Red Numbers: Present Temperature, Green Numbers: Set point temperature Buttons: P, Arrows: UP and Down * P: change settings and confirm, * UP and Down: change numbers. Alw...") |
Dagkd@uio.no (talk | contribs) |
||
| Line 16: | Line 16: | ||
Press and hold U till the greed dot shows, then release. (behind the green number) | Press and hold U till the greed dot shows, then release. (behind the green number) | ||
| + | |||
| + | The programmable hotplate is not reliable. '''Please check''' | ||
| + | * Two times in a row the same procedure for 25 um thick substrate with VWR and programmable hot plates gave good results for VWR hotplate but overdevelopment for programmable hotplate. | ||
| + | * I have observed that the programmable hotplate seems to spend too long time at each step. | ||
Revision as of 15:05, 10 November 2023
Red Numbers: Present Temperature,
Green Numbers: Set point temperature
Buttons: P, Arrows: UP and Down
- P: change settings and confirm,
- UP and Down: change numbers.
Always press P to change and confirm settings.
P --->Temperature: Pr.51 65->P --->Time: Pr.t1 15->P --->Temperature: Pr.52 95 ->P --->Time: Pr.t2 99.99->P ---->Temperature: Pr.53 95->P ---->Time: Pr.t2 20->P
Note: The time is correct with actual timer check.
Start the program:
Press and hold U till the greed dot shows, then release. (behind the green number)
The programmable hotplate is not reliable. Please check
- Two times in a row the same procedure for 25 um thick substrate with VWR and programmable hot plates gave good results for VWR hotplate but overdevelopment for programmable hotplate.
- I have observed that the programmable hotplate seems to spend too long time at each step.
