Autoclaving
From mn.fysikk.laglivlab
Equipment
- Autoclave scotch
- 1L tap water
For autoclaving liquids:
- Borosilicate bottle
Other:
- Glass beaker
- Aluminum foil
General procedure
- Prepare items that will be autoclaved:
- Liquids: Fill borosilicate bottle with solution. Untighten cap slightly and put autoclave tape across lid, touching bottle on both ends.
- Others: Fill beaker and cover top with aluminum foil. Fasten with autoclave tape.
- Fill autoclaver with 1L water and put items inside.
- ...
Autoclaved water
Must be done 4-5 hours before use of water (for cooling down)
- Get 5L bottles of water from chemistry (check quality resistivity > 1 Ohms) or use the stock in 420
- Fill 1L borosilicate bottle with water
- Put cap on, untighten it slightly
- Put autoclave scotch the lid and the bottle. One piece of scotch should cover both
- Put in autoclave and follow procedure on autoclave
Autoclaving pasteur pipettes
- stock in 420 or in cupboard in 431
- put them in a 1L beaker, tips at the bottom, beware not to break any
- put some aluminum foil on top to close the beaker and fasten it into place with autoclave tape
- put it in the autoclave and follow the autoclave's procedures