Difference between revisions of "20220404 cell adhesion"
From mn.fysikk.laglivlab
Dagkd@uio.no (talk | contribs) (Created page with "Followed the procedure = Assembling the chip = * Clean glass slide with IP and N2 * Punch holes for fluid inlets ** For 1/16" tubes use OD?? punch ** For thin teflon tube use...") |
Dagkd@uio.no (talk | contribs) |
||
Line 24: | Line 24: | ||
** Sterilize the tubes | ** Sterilize the tubes | ||
== Sterilizing == | == Sterilizing == | ||
− | + | No sterilizing today, everything was done in 420 instead of in 431 | |
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
== Water filling == | == Water filling == | ||
* Fill a small amount of distilled water in beaker | * Fill a small amount of distilled water in beaker |
Revision as of 10:43, 4 April 2022
Followed the procedure
Contents
Assembling the chip
- Clean glass slide with IP and N2
- Punch holes for fluid inlets
- For 1/16" tubes use OD?? punch
- For thin teflon tube use OD?? punch
- Place both PDMS and glass slide with clean sides up on glass plate in plasma cleaner
- Follow instructions for Plasma treatment
- Placed the PDMS on top of the glass slide and watch it attach
- Some pressure needed to be applied to bond
Filling the chip
For sterilizing and filling the chip with water and fibronectin you need
- 1ml syringe with
- 20G needle and
- 2cm long 1/16" teflon tube on the needle.
- small beaker
- ethanol
- distilled water
- Eppendorf tube of fibronectin
- Cells in fresh media
- Inlet and outlet tubes
- Measure lengths of inlet and outlet tubes and cut
- Sterilize the tubes
Sterilizing
No sterilizing today, everything was done in 420 instead of in 431
Water filling
- Fill a small amount of distilled water in beaker
- Retract <1ml distilled water into tube/needle/syringe
- Fit in inlet of chip and fill slowly
- Empty syringe and needle to be ready to use for fibronectin
Fibronectin filling
- Take one Eppendorf with 0.5 ml fibronectin form freezer
- Thaw the fibronectin
- Retract fibronectin into tube/needle/syringe
- fit in inlet of chip and fill slowly
- Attach inlet and outlet tubes
- Incubate for 30 min in incubator
- Rinse with PBS
- Details?
- Pour ~?? ml PBS in sterile beaker
- Fill sterile ?? ml syringe+needle with PBS
- Slowly flow PBS through chip