Difference between revisions of "20211110 Microfluidic plasma and fibronectin aliquoting"
(Created page with "==Restart of project== ===Microfluidic preparation=== We started by assembling the microfluidic chip. PDMS had been prepared in advance. We plasma treated the PDMS and one nor...") (Tag: Visual edit) |
(Tag: Visual edit) |
||
| Line 3: | Line 3: | ||
We started by assembling the microfluidic chip. PDMS had been prepared in advance. We plasma treated the PDMS and one normal, untreated glass slide in the plasma cleaner. We did not place a drop of water on one of the inlets, as we agreed to do this with the fibronectin later. | We started by assembling the microfluidic chip. PDMS had been prepared in advance. We plasma treated the PDMS and one normal, untreated glass slide in the plasma cleaner. We did not place a drop of water on one of the inlets, as we agreed to do this with the fibronectin later. | ||
===Fibronectin aliquoting=== | ===Fibronectin aliquoting=== | ||
| − | After having assembled the microfluidic chips, we prepared the fibronectin as instructed in the [https:// | + | After having assembled the microfluidic chips, we prepared the fibronectin as instructed in the [https://www.mpbio.com/media/document/file/datasheet/dest/m/p/_/d/s/_/0/2/1/5/0/MP_DS_02150025.pdf protocol]. We then placed a drop of prepared fibronectin onto one of the inlets of the microfluidic chip so that the channel was coated. Due to the plasma treatment being uneven, we experienced some spots without fibronectin. Next we incubated the coated chip at 37 degrees Celsius for about half an hour. In the meantime, we divided the prepared fibronectin between 40 eppendorf tubes which we then froze for later use. |
=== Injecting cells === | === Injecting cells === | ||
Then we passaged our cells and removed some of them in order to inject cells into the coated chip. After injecting the cells we left them for about an hour at 37 degrees Celsius. When we came back, some of them had attached and adhered to the fibronectin-covered surface of the chip. | Then we passaged our cells and removed some of them in order to inject cells into the coated chip. After injecting the cells we left them for about an hour at 37 degrees Celsius. When we came back, some of them had attached and adhered to the fibronectin-covered surface of the chip. | ||
Revision as of 01:13, 15 November 2021
Contents
Restart of project
Microfluidic preparation
We started by assembling the microfluidic chip. PDMS had been prepared in advance. We plasma treated the PDMS and one normal, untreated glass slide in the plasma cleaner. We did not place a drop of water on one of the inlets, as we agreed to do this with the fibronectin later.
Fibronectin aliquoting
After having assembled the microfluidic chips, we prepared the fibronectin as instructed in the protocol. We then placed a drop of prepared fibronectin onto one of the inlets of the microfluidic chip so that the channel was coated. Due to the plasma treatment being uneven, we experienced some spots without fibronectin. Next we incubated the coated chip at 37 degrees Celsius for about half an hour. In the meantime, we divided the prepared fibronectin between 40 eppendorf tubes which we then froze for later use.
Injecting cells
Then we passaged our cells and removed some of them in order to inject cells into the coated chip. After injecting the cells we left them for about an hour at 37 degrees Celsius. When we came back, some of them had attached and adhered to the fibronectin-covered surface of the chip.
